Интерактивная система просмотра системных руководств (man-ов)
if_cue (4)
>> if_cue (4) ( FreeBSD man: Специальные файлы /dev/* )
BSD mandoc
NAME
cue
- CATC USB-EL1210A USB Ethernet driver
SYNOPSIS
To compile this driver into the kernel,
place the following lines in your
kernel configuration file:
device uhcidevice ohcidevice usbdevice cue
Alternatively, to load the driver as a
module at boot time, place the following line in
loader.conf5:
if_cue_load="YES"
DESCRIPTION
The
driver provides support for USB Ethernet adapters based on the Computer
Access Technology Corporation's USB-EL1210A chipset.
The USB-EL1210A supports a 512-bit multicast hash filter, single perfect
filter entry for the station address and promiscuous mode.
Packets are
received and transmitted over separate USB bulk transfer endpoints.
The CATC chipset supports only 10Mbps half-duplex mode, hence there
are no
ifmedia(4)
modes to select.
For more information on configuring this device, see
ifconfig(8).
HARDWARE
The
driver supports CATC USB-EL1210A based USB Ethernet
adapters including:
Belkin F5U011/F5U111
CATC Netmate
CATC Netmate II
SmartBridges SmartLink
DIAGNOSTICS
"cue%d: watchdog timeout"
A packet was queued for transmission and a transmit command was
issued, however the device failed to acknowledge the transmission
before a timeout expired.
"cue%d: no memory for rx list"
The driver failed to allocate an mbuf for the receiver ring.
