Интерактивная система просмотра системных руководств (man-ов)
pst (4)
>> pst (4) ( FreeBSD man: Специальные файлы /dev/* )
BSD mandoc
NAME
pst
- device driver for Promise Supertrak SX6000
SYNOPSIS
To compile this driver into the kernel,
place the following line in your
kernel configuration file:
device pst
Alternatively, to load the driver as a
module at boot time, place the following line in
loader.conf5:
pst_load="YES"
DESCRIPTION
This driver is for the Promise Supertrak SX6000 ATA hardware RAID controller.
It supports (in hardware) RAID levels 0, 1, 0+1, 3, 5 and JBOD on up to
6 ATA disk drives, including automatic rebuild and hotswap, and supports
signalling disk status on LEDs on Promise Superswap disk enclosures.
The Supertrak line of controllers does not support non-disk devices.
HARDWARE
The
driver supports the Promise Supertrak SX6000 ATA hardware RAID
controller.
NOTES
The
driver does not support manipulating the RAID from the OS, RAIDs need
to be set up from the onboard BIOS.
However, hot swap, hot spare, and
automatic rebuilds are supported without a reboot.
HISTORY
The
driver first appeared in
Fx 4.7 .
AUTHORS
The
driver and man page was written by
An S/oren Schmidt
Aq sos@FreeBSD.org .
