Исходное сообщение
"Связать Cisco 1841 и два Catalyst 2960 последовательно" Отправлено KudriK_TF, 08-Фев-10 09:00
>и еще: > >#show run int vla 1 с первого: Switch#sh int tru Switch#sh int trunk Port        Mode             Encapsulation  Status        Native vlan Gi0/1       on               802.1q         trunking      1 Port        Vlans allowed on trunk Gi0/1       1-4094 Port        Vlans allowed and active in management domain Gi0/1       1 Port        Vlans in spanning tree forwarding state and not pruned Gi0/1       1 Switch#sh cd Switch#sh cdp neighbors Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge                   S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID Router           Fas 0/1           170          R S I     1841      Fas 0/0 Switch           Gig 0/1           172           S I      WS-C2960- Gig 0/1 Switch#sh run int vla 1 Building configuration... Current configuration : 81 bytes ! interface Vlan1 ip address 172.16.0.2 255.255.255.128 no ip route-cache end со второго Switch#sh run int vla 1 Building configuration... Current configuration : 91 bytes ! interface Vlan1 ip address 172.16.0.3 255.255.255.128 no ip route-cache shutdown Switch#sh int tru Port        Mode             Encapsulation  Status        Native vlan Gi0/1       on               802.1q         trunking      1 Port        Vlans allowed on trunk Gi0/1       1-4094 Port        Vlans allowed and active in management domain Gi0/1       1-2 Port        Vlans in spanning tree forwarding state and not pruned Gi0/1       1-2 Switch# Switch#sh cdp neighbors Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge                   S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID Switch           Gig 0/1           135           S I      WS-C2960- Gig 0/1 вот, то что просил end