>sh int fa4 в студию FastEthernet4 is up, line protocol is up
Hardware is PQUICC_FEC, address is 0021.a03e.e825 (bia 0021.a03e.e825)
Internet address is 10.1.3.214/24
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:02, output 00:00:30, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 1 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
42 packets input, 3580 bytes
Received 42 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
350 packets output, 142157 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
ping 195.34.32.116
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 195.34.32.116, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 172/207/288 ms
>А ip route 0.0.0.0 0.0.0.0 <ip-адрес шлюза> вы выставлять не собираетесь? ;)
Адрес с dhcp приходит... Как это прописать? В таблице роутинга правильный шлюз по умолчанию появляется, NAT просто "на интерфейс" тоже вроде прописан.
