Move the whole linux-2.2.16 directory somewhere else where the directory-name doesn't have spaces in itself.
You will have to look for some other software that will support your remote control. Look in the Remote programs URL section.
Look in Configuring - NBP Network Boot Program
Get a torch and heat the opposite side of the plexiglass that you are going to bend. You should move the torch back and forth, not to fast, and not too slow. One minute - two minutes should be fine, if you warm up it too much, bubbles will appear. After you have heated the material, put in on table and slowly bend it. Keep it under the desired angle up to a minute.
Go into the BIOS settings and change the Video Mode (it might be called something else on your system) and change from CGA/EGA or VGA to None.
Закладки на сайте
Проследить за страницей
Created 1996-2021 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру