The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

ng_sppp (4)
  • >> ng_sppp (4) ( FreeBSD man: Специальные файлы /dev/* )

  • BSD mandoc
     

    NAME

    
    
    ng_sppp
    
     - sppp netgraph node type
    
     
    

    SYNOPSIS

       #include <netgraph/ng_sppp.h>
     

    DESCRIPTION

    An sppp node is a netgraph(4) interface to the original sppp(4) network module for synchronous lines. Currently, sppp(4) supports PPP and Cisco HDLC protocols. An sppp node could be considered as an alternative kernel mode PPP implementation to net/mpd port + ng_ppp4, and as an alternative to ng_cisco4 node. While having less features than net/mpd + ng_ppp4, it is significantly easier to use in the majority of simple configurations, and allows the administrator to not install the net/mpd port. With sppp you do not need any other nodes, not even an ng_iface4 node. When an sppp node is created, a new interface appears which is accessible via ifconfig(8). Network interfaces corresponding to sppp nodes are named sppp0 , sppp1 etc. When a node is shut down, the corresponding interface is removed, and the interface name becomes available for reuse by future sppp nodes. New nodes always take the first unused interface. The node itself is assigned the same name as its interface, unless the name already exists, in which case the node remains unnamed. The sppp node allows drivers written to the old sppp(4) interface to be rewritten using the newer more powerful netgraph(4) interface, and still behave in a compatible manner without supporting both network modules.

    An sppp node has a single hook named downstream Usually it is connected directly to a device driver hook.

    The sppp nodes support the Berkeley Packet Filter, bpf(4).  

    HOOKS

    This node type supports the following hooks:

    downstream
    The connection to the synchronous line.

     

    CONTROL MESSAGES

    This node type supports the generic control messages, plus the following:

    NGM_IFACE_GET_IFNAME
    Returns the name of the associated interface as a NUL -terminated ASCII string. Normally this is the same as the name of the node.

     

    SHUTDOWN

    This node shuts down upon receipt of a NGM_SHUTDOWN control message. The associated interface is removed and becomes available for use by future sppp nodes.

    Unlike most other node types and like ng_iface4 does, an sppp node does not go away when all hooks have been disconnected; rather, an explicit NGM_SHUTDOWN control message is required.  

    EXAMPLES

    For example, if you have the cx(4) device, you could run PPP over it with just one command:

    "ngctl mkpeer cx0: sppp rawdata downstream"

    Now you have the sppp0 interface (if this was the first sppp node) which can be accessed via ifconfig(8) as a normal network interface, or via spppcontrol(8) as an sppp(4) interface.  

    SEE ALSO

    bpf(4), cx(4), netgraph(4), ng_cisco4, ng_iface4, ng_ppp4, sppp(4), ifconfig(8), ngctl(8), spppcontrol(8)

    For complex networking topologies you may want to look at net/mpd port.  

    HISTORY

    The sppp node type was implemented for Fx 5.0 . It was included to the system since Fx 5.3 .  

    AUTHORS

    Copyright (C) 2003-2004 An Roman Kurakin Aq rik@cronyx.ru .


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    HOOKS
    CONTROL MESSAGES
    SHUTDOWN
    EXAMPLES
    SEE ALSO
    HISTORY
    AUTHORS


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру